How To Fix Samsung S22 Ultra With Red Temperature Warning Symbol: Difference between revisions
(Updated description) |
No edit summary |
||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
{{Repair Guide | {{Repair Guide | ||
|Device= | |Device=Galaxy S22 Ultra | ||
|Affects parts=Main Logic Board | |Affects parts=Main Logic Board | ||
|Needs equipment=Soldering Iron, Hot Air Station, Microscope | |Needs equipment=Soldering Iron, Hot Air Station, Microscope | ||
Line 6: | Line 6: | ||
|Difficulty=4. Specialist | |Difficulty=4. Specialist | ||
}} | }} | ||
==Problem description== | ==Problem description== | ||
Samsung S22 Ultra has a common fault where it will give you a red exclamation mark warning when you plug in the charger. | Samsung S22 Ultra has a common fault where it will give you a red exclamation mark warning when you plug in the charger. | ||
Line 38: | Line 36: | ||
# Boot from a DC Power Supply | # Boot from a DC Power Supply | ||
# Boot with a fully charged battery. | # [[File:U7002.png|alt=Samsung S22 Ultra - Picture of U7002 IC that needs to be replaced if USB_THM is shorted|thumb|Samsung S22 Ultra - Picture of U7002 IC that needs to be replaced if USB_THM is shorted]]Boot with a fully charged battery. |
Latest revision as of 06:15, 1 May 2024
How To Fix Samsung S22 Ultra With Red Temperature Warning Symbol | |
---|---|
Device | Galaxy S22 Ultra |
Affects part(s) | Main Logic Board |
Needs equipment | Soldering Iron, Hot Air Station, Microscope |
Difficulty | ◉◉◉◉ Specialist |
Type | BGA, Soldering |
Problem description
Samsung S22 Ultra has a common fault where it will give you a red exclamation mark warning when you plug in the charger.
If the device boots, it will say it's either very hot or very cold & it cannot charge & will shut down. This can happen out of nowhere. S22 Ultra also does not require the wireless coil/back cover to prevent the temp warning, like some of the older models do. A fully working S22 Ultra will charge fine without the wireless coil/back cover.
This issue lies within the motherboard itself
Symptoms
- Does not charge
- Show red exclamation mark error message
Solution
Diagnostic Steps
Check the 3rd pin form the top right of the charging port FPC (SOC25000). The line is called USB_THM (USB Thermistor) which is the temp sensor line for the board.
The known good reading should be 0.717V
If you get a low reading like 0.003V, then the line is shorted.
Repair Steps
To repair the shorted USB_THM line, you must replace the U7002 IC. This is a PMIC inside the Samsung Sandwich.
IC name is "Qualcomm PM8350"
This is extremely difficult to do, as the 2 layers are soldered together with lead free high temp solder.
Although, there are a few workarounds to get it to power on & allow you to extract the user data
- Boot from a DC Power Supply
- Boot with a fully charged battery.